User Documentation

Introduction

Your Wombat Ware Cooling Case can cool down your iPad  when it is warm (above 40 degrees celsius) and bring down its temperature by 5 - 10 degrees celsius, potentially preventing it from overheating and shutting down when it gets above 45 degrees celsius. 

Features

• Light & Portable : The case provides some amount of bump/drop protection to your iPad especially at the corners.
• Effective Cooling : 2 x Sunon mighty mini blower fans that creates an airflow at the back of your iPad.
• Cooling when needed : When turned on, the built-in temperature sensor will monitor the temperature and turn on the blower fans.
• Stress Free for hours : 650mah battery will power the fans for up to 5 hours.
• Usability : The mounting holes at the back are compatible with mounting accessories that rely on the 4-hole AMPS pattern.
• Modular Design : The cooling body can be removed from the iPad Mini 6 / 7 Cover and fitted to a different Cover or a future Mini Cover. More on the Cooling Body design: link.

Specifications

Safety Instructions

• Please read and follow the instructions in this document
• Keep the product away from heat sources such as fires, flammable or explosive gas etc.
• This product is not water-proof. Do not immerse it in water, it will damage the electronics.

What’s in the box

1. The iPad Cooling Case 
2. A USB-C to USB-A cable for charging
3. 4 x M4 nuts 
4. 4 x M4 x 16mm screws for compatible mounting options

Putting the iPad into the iPad Case

Slide the iPad into the iPad Case from the front using the longer edge. Then push each of the four corners of the iPad into the iPad Case. The iPad Case should snap onto the iPad as you push in on each corner. Ensure that the four edges of the iPad Case are holding down the iPad nicely.

Charging the Cooling Backpack

Charge the Backpack using the USB-C cable supplied. Plugin the USB-C cable connector into the Cooling Backpack USB-C port. Ensure the other end (USB-A) is plugged into a USB power adaptor with 5V & 1A/2A output.

The green LED will turn on during charging. When the battery is fully charged, the green LED will be off. It takes up to around 3 hours to fully charge a flat battery.

Using the Cooling Case

Switch on the Cooling Body by pushing the sliding switch to the left (when facing the Cooling Body). Once switched on, the built-in temperature sensor will start monitoring the temperature. When it gets over 32°C or 90°F, it will activate the fans and the blue LED will come on.

[NOTE: if you bought your cooling case after 15 Aug 2024, the fans will turn on for the first second on switching on, to show the fans are working.]

When to charge the Backpack again

When the battery is fully charged, the Backpack could last for up to 5 hours.

When the red LED starts flashing, the battery is at half capacity (50%) or less. When the red LED is on (solid), the battery is at 20% capacity or less.

Warranty 

Wombat Ware warrants this product against defects in materials and/or workmanship under normal use for a period of one year from the date of purchase by the original purchaser. Please retain the tax invoice as evidence of purchase

Compliance Info

The Wombat Ware Cooling Case has passed EMC compliance tests and complies with the applicable requirements of FCC Rule Part 15 as well as the rules for the Regulatory Compliance Mark (RCM).

For more information, go to our support/faq page or check out our video tutorials on YouTube.